Voltmeter vs. Ammeter

Difference Between Voltmeter and Ammeter Voltmeters and ammeters are widely used in the physics, electronic engineering, and electrical…

Difference Between Voltmeter and Ammeter

Voltmeters and ammeters are widely used in the physics, electronic engineering, and electrical engineering. Both the ammeter and the voltmeter are used to measure properties of electronic and electrical circuits. These instruments are mostly based on a conductor coil placed in a strong magnetic field, but other forms of these devices such as digital voltmeters and ammeters, multimeters, potentiometers, current balances, and electrostatic voltmeters are also common.


The unit “Volt” is named in honor of Alessandro Volta. It is used to measure the latent of a point or potential disparity between two points. Frequently the voltmeter is a difference of the galvanometer. A very high resistor set up in series with the galvanometer makes the basic voltmeter. Voltmeters have ranges from a few microvolts to about a few Gigavolts. As described earlier, the basic voltmeter consists of a current carrying coil placed inside an external magnetic field. The magnetic field due to the current carrying coil repulses the permanent magnetic field. This effect causes an indicator fond of to the coil to rotate; this indicator coil system is spring loaded, thereby bringing the indicator back to zero pointers when no current is present. The angle of the indicator turn is comparative to the current present in the coil. The digital voltmeter uses an analog to digital conversion (ADC) to convert the present voltage to a digital value. But the incoming signal must be amplified or reduced depending on the measuring range used in the instrument before it can be displayed as a digital value. The main problem involving voltmeters is that, they have a finite resistance value; preferably, a voltmeter should have infinite impedance, which means it must not draw any current from the circuit. Though, this is not the case with real voltmeters. A real voltmeter must have to draw a current from the circuit in order to produce the repulsive magnetic field. Though, this can be minimized by using amplifiers so that the commotion to the circuit is negligible.


Ammeter is also a variation of the galvanometer. It uses the galvanometer’s principle of representing the current variation. The current is measured in amperes (A). Thereby, ammeters, which measure in milliamperes is known as the milliammeter, and microampere ranged ammeter is known as the microammeter. Ideally, an ammeter should have a zero resistance value, but materials with zero resistivity are not there. Therefore, every ammeter has an inbuilt error. There are very precise ammeters, such as: current balance. The ammeter also comes in the forms of moving iron ammeters, hot wire ammeters, and digital ammeters.


Leave a Reply

Your email address will not be published. Required fields are marked *

Related Posts

River vs. Lake

Difference Between River and Lake Water, that covers more than half of the Earth’s surface, is present in…

Friction Vs. Gravity

Difference Between Friction And Gravity Friction and Gravity If you think about it for a minute, you will…